Removing An Application From A Region - Cisco Nexus 5000 Series Configuration Manual

Configuring CFS over IP

Removing an Application from a Region

Removing an application from a region is the same as moving the application back to the default region
(Region 0), which brings the entire network into the scope of distribution for the application.
Procedure
Step 1
Step 2
Step 3
Deleting CFS Regions
Deleting a region nullifies the region definition. All the applications bound by the region are released back
to the default region.
Procedure
Step 1
Step 2
Configuring CFS over IP
Enabling CFS over IPv4
You can enable or disable CFS over IPv4.
CFS cannot distribute over both IPv4 and IPv6 from the same switch.
Note
Cisco Nexus 5000 Series NX-OS System Management Configuration Guide, Release 5.2(1)N1(1)
52
Command or Action
switch# configure
switch(config)# cfs region region-id
switch(config-cfs-region)# no application
Command or Action
switch# configure
switch(config)# no cfs region
region-id
Using Cisco Fabric Services
Purpose
Enters configuration mode.
Enters CFS region configuration submode.
Removes application(s) that belong to the
region.
Purpose
Enters configuration mode.
Deletes the region.
You see the, "All the applications in the
Note
region will be moved to the default region"
warning.