GE T60 Instruction Manual page 295

CHAPTER 5: SETTINGS PRODUCT SETUP
— This setting controls the behavior of the user-programmable pushbutton on message that is
PUSHBTN 1 MESSAGE
programmed in the and settings, and the behavior of the user-programmable pushbutton
PUSHBTN 1 ID PUSHBTN 1 ON TEXT
off message that is programmed in the and settings.
PUSHBTN 1 ID PUSHBTN 1 OFF TEXT
When set to "Disabled", user-programmable pushbutton messages do not display. Otherwise the on message displays
when the user-programmable pushbutton becomes activated, and if in the "Latched" mode the off message displays when
the user-programmable pushbutton becomes deactivated.
When set to "Normal", the duration the message displays is as specified by the setting.
FLASH MESSAGE TIME
When set to "High Priority", the duration of the off message is as specified by the setting, but the on
FLASH MESSAGE TIME
message is displayed as long as the user-programmable pushbutton is activated. While activated, target and other
messages are suppressed. To allow front panel keypad operation, when a keypad button is pressed the message is
supressed for 10 seconds.
— If this setting is enabled, each user-programmable pushbutton state change is logged as an
PUSHBUTTON 1 EVENTS
event into the event recorder.
The figures show the user-programmable pushbutton logic.
Figure 5-49: User-programmable pushbutton logic (Sheet 1 of 2)
5
T60 TRANSFORMER PROTECTION SYSTEM – INSTRUCTION MANUAL 5-113