User-Definable Displays - GE T60 Instruction Manual

CHAPTER 5: SETTINGS

5.3.16 User-definable displays

5.3.16.1 Menu
SETTINGS  PRODUCT SETUP  USER-DEFINABLE DISPLAYS
 USER-DEFINABLE
 DISPLAYS
This menu provides a mechanism for manually creating up to 16 user-defined information displays in a convenient
viewing sequence in the
USER DISPLAY
facilitate text entry and Modbus register data pointer options for defining the user display content.
Once programmed, the user-definable displays can be viewed in two ways.
• Keypad — Use the
MENU
only the programmed screens are displayed). The screens can be scrolled using the up and down arrow keys. The
display disappears after the default message time-out period specified by the
 DEFAULT MESSAGE TIMEOUT
• User-programmable control input — The user-definable displays also respond to the
FlexLogic operand (in particular, the user-programmable pushbutton operands), can be used to navigate the
programmed displays.
On the rising edge of the configured operand (such as when the pushbutton is pressed), the displays are invoked by
showing the last user-definable display shown during the previous activity. From this moment onward, the operand
acts exactly as the down key and allows scrolling through the configured displays. The last display wraps up to the
first one. The
INVOKE AND SCROLL
When the default timer expires (set by the
displays. The next activity of the
at the first user-defined display. The
5.3.16.2 User display 1(16)
SETTINGS  PRODUCT SETUP  USER-DEFINABLE DISPLAYS  USER DISPLAY 1(16)
 USER DISPLAY 1

Any existing system display can be automatically copied into an available user display by selecting the existing display and
pressing the key. The display then prompts with ADD TO USER DISPLAY LIST? After selecting "Yes," a message
ENTER
indicates that the selected display has been added to the user display list. When this type of entry occurs, the sub-menus
are automatically configured with the proper content—this content can be edited subsequently.
T60 TRANSFORMER PROTECTION SYSTEM – INSTRUCTION MANUAL
INVOKE AND SCROLL:

Off
 USER DISPLAY 1



 USER DISPLAY 16


menu (between the
TARGETS
key to select the
USER DISPLAY
setting.
input and the down arrow key operate concurrently.
DEFAULT MESSAGE TIMEOUT
input stops the cycling at the currently displayed user display, not
INVOKE AND SCROLL
INVOKE AND SCROLL
DISP 1 TOP LINE:

DISP 1 BOTTOM LINE:

DISP 1 ITEM 1:

0

DISP 1 ITEM 5:

0
Range: FlexLogic operand
See below
and top-level menus). The sub-menus
ACTUAL VALUES
menu item to access the first user-definable display (note that
PRODUCT SETUP  DISPLAY PROPERTIES
setting), the relay starts to cycle through the user
pulses must last for at least 250 ms to take effect.
Range: up to 20 alphanumeric characters
Range: up to 20 alphanumeric characters
Range: 0 to 65535 in steps of 1
Range: 0 to 65535 in steps of 1
PRODUCT SETUP
setting. Any
INVOKE AND SCROLL
5-115
5