Buffer Full - KoamTac KDC20 User Manual

and you will hear beeping sound.
3.6

Buffer Full

The KDC will display the message
160KB (85 version) / 60KB (86 version) or the number of collected barcodes is 10,240. To
prevent the loss of data, you should synchronize the data then reset the memory when
this message displays.
4MB version KDC reaches Buffer Full condition as follows:

0.5MB Partition - Collected data size reaches 0.5MB or collected number is
25,600

1MB Partition - Collected data size reaches 1MB or collected number is 51,200

2MB Partition - Collected data size reaches 2MB or collected number is 102,400

3MB Partition - Collected data size reaches 3MB or collected number is 153,600

4MB Partition - Collected data size reaches 4MB or collected number is 204,800
3.7 Power-on/off
You can turn the power on and off by pressing DOWN and SCAN button simultaneously
for 5 seconds. When the LED light is in green, you can release the buttons and the
power is on. When you turn off your KDC20, you will hear a beep sound after you press
DOWN and SCAN buttons simultaneously.
3.8 Replace Battery
KDC comes with a rechargeable, Lithium-polymer battery. The battery is recharged from
any USB port or KDC charging cradle and can be recharged about 300 times before it
needs to be replaced. KoamTac recommends replacing the battery every six months as
a declining battery will cause noticeable performance degradation in KDC. Replacement
batteries can be purchased from a KoamTac distributor. Batteries should be disposed
properly according to the WEEE regulation. The steps for replacing the battery are as
follows.
Disassemble the KDC back cover by unscrewing the middle screw.
1.
Remove old battery and replace with new battery.
2.
Reassemble the back cover.
3.
1
Buffer Full
when the size of collected data reaches
46
Unscrew the screw indicated by the arrow.
KDC User Manual
Revision 3.05.R6
Copyright ® 2014, KoamTac, Inc.