Operating The Kdc - KoamTac KDC20 User Manual

3. Operating the KDC

3.1 Getting Started
3.1.1 Attach Lanyard/Hand strap to KDC
To prevent possible damage to the KDC, we
your neck or hand by the included Lanyard/Hand strap. Also, please don't swing KDC
by the Lanyard/Hand strap because contact with another object may cause it to
malfunction or become damaged.
To attach the Lanyard:
1. Fit the thin end of Lanyard through the pillar of the KDC.
2. Loop the thick end of strap through the thin loop
3. Pull the strap tight to secure
3.1.2 Charge KDC Battery
Prior to using the KDC, you must charge its battery. It will take approximately 2 hours to
charge your KDC20. To charge the battery, follow the directions below.
1. Connect the KDC cable to the mini USB connector on the KDC.
Connect the KDC cable to Type A USB connector on your computer.
2.
Your KDC battery will begin charging. Within a few minutes, two small LEDs on the front
panel will illuminate orange. When the battery is fully charged, the LEDs will illuminate
green.
3.1.3 Configure KDC
The KDC is designed to meet the data collection requirements of many different
industries in a variety of dynamic situations. To perform well in these diverse
environments, the KDC is designed to be configured easily and quickly. But, to perform
strongly
recommend wearing it around
28
Revision 3.05.R6
Copyright ® 2014, KoamTac, Inc.
KDC User Manual