G. Install Fan Brackets - Heat & Glo SLR-X-AU Installation Manual

G. Install Fan Brackets

NOTICE: These brackets are designed to improve the
effeciency of the fan performance by directing discharge
air through the CFT decorative front more effiecently.
1. Locate the fan brackets that are enclosed in the
manual bag assembly. Separate into left and right
brackets by bending the bracket at the perforation
until it breaks and the pieces are separated. See
Figure 11.2.
2. Install the right bracket by installing it over the glass
frame as shown in Figure 11.3.
3. Repeat Step 6 for left bracket. Notice the "L" indicator
on the left fan bracket.
BEND BRACKET AT PERFORATION
Figure 11.2 Separate Fan Bracket into Left and Right Brackets
52
RIGHT BRACKET
LEFT BRACKET
"L" INDICATOR
Heat & Glo • SLR-X-AU Installation Manual • 2493-980 Rev. B • 12/17
Figure 11.3 Separate Fan Bracket into Left and Right Brackets
H. Install Decorative Front
WARNING! Risk of Fire! Install ONLY decorative fronts
approved by Hearth & Home Technologies. Unapproved
decorative fronts could cause fireplace to overheat.
This fireplace has been supplied with an integral barrier
to prevent direct contact with the fixed glass panel. DO
NOT operate the fireplace with the barrier removed.
Contact your dealer or Hearth & Home Technologies if
the barrier is not present or help is needed to properly
install one.
For more information refer to the instructions supplied with
your decorative front.