E. Install Media Option - Heat & Glo SLR-X-AU Installation Manual

E. Install Media Option

WARNING
Delayed Ignition Risk
• Place media according to instructions.
• Do NOT place media in area in front of pilot
• Do NOT place media in a position that they may
fall into area in front of pilot.
• Do NOT use any media other than the Hearth
& Home Technologies-supplied options for this
fireplace model.
Fireplace will not function properly.
Delayed ignition may occur.
WARNING
Risk of Asphyxiation or Fumes.
• Place media according to instructions.
• Do NOT place media in area between glass and
firebox.
• Do NOT place media in a position that they may
fall into area between glass and firebox.
• Do NOT use any media other than the media
approved with this fireplace.
Fireplace will not function properly.
Gas leak may occur.
This appliance is approved for use with the following:
• Decorative Glass Media
• Decorative Ceramic Stones
• Driftwood Logs
• Traditional Logs
The decorative glass media, driftwood logs and ceramic
stones all utilize the standard burner installed in the
appliance. The traditional log option requires a burner
replacement which is included in the kit.
Heat & Glo • SLR-X-AU Installation Manual • 2493-980 Rev B • 12/17
F. Install Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fixed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fireplace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Replacing Fixed Glass Assembly
The bottom glass latches have been designed to create
a small gap between the glass clip and the face of the
appliance. See Figure 11.1.
1. Install the bottom of the glass assembly so that the two
tabs on the bottom of the glass latch engage the gap.
By tilting the top of the glass towards the face of the
appliance, tension will be applied to the bottom two
glass latches. Use one hand to support the glass at
all times.
2. Fasten the two upper glass latches, one at a time, by
pulling out and downward into position on the glass as-
sembly. Use one hand to support the glass at all times.
3. Verify that the top two glass latches are engaged by
visually verifying that glass latches have engaged both
left and right tabs on the glass frame.
4. Verify the bottom two glass latches have engaged the
glass frame tabs by grasping the bottom of the glass
frame assembly and pulling the glass frame assembly
"away" from the face of the appliance and "release" the
glass frame. The spring action of the clips will "pull"
the glass frame assembly towards the face of the ap-
pliance if bottom clips are properly engaged. If the
glass frame assembly does not pull back towards the
face of the appliance, repeat steps 1-4.
WARNING! Risk of Explosion! Risk of Asphyxiation!
Glass latches MUST be properly engaged. Inspect glass
seal before installing decorative front. Gas could leak!
5. Reinstall decorative front.
51