Heat & Glo SLR-X-AU Installation Manual page 41

2. Remove the two screws that secure the pilot shield
to the burner bracket and remove the two screws
that secure the pilot assembly to the burner bracket.
Remove the one screw that secures the burner bracket
to the valve plate. See Figure 9.2. Gently push the
pilot assembly backwards to allow for the burner to be
removed.
3. Remove the screw that secures the burner bracket to
the valve plate. See Figure 9.2.
4. Slide burner assembly to the left to disengage the
burner tube from the orifice. Remove the burner from
the appliance.
5. Remove the nine screws around the perimeter of the
valve plate that secure valve plate to the appliance.
See Figure 9.3.
6. Lift up on the plate assembly. Disconnect the ball
valve assembly from the gas valve by loosening the
compression fitting located on the left side of the gas
valve.
7. Upon completion of service, reverse steps 1-6. If the
valve plate gasket is damaged, replace the gasket
prior to reinstallation of valve plate assembly.
REMOVE PILOT SCREWS
REMOVE BURNER SCREW
Figure 9.2 Burner Removal
Heat & Glo • SLR-X-AU Installation Manual • 2493-980 Rev B • 12/17
REMOVE 9 SCREWS
Figure 9.3 Remove Valve Plate
Valve Pressure Taps
The pressure taps are accessible by removing the lower
panel prior to finishing material installation. There is
limited access to the pressure taps after finishing material
installation. Remove glass assembly and utilize an
appropriate sized screwdriver. See Figure 8.2.
41