B. Wiring Requirements - Heat & Glo SLR-X-AU Installation Manual

B. Wiring Requirements

IntelliFire™ Plus Ignition System Wiring
• Wire the appliance junction cord to 220/240 VAC for
proper operation of the appliance.
WARNING! Risk of Shock or Explosion! DO NOT wire
IPI controlled appliance junction cord to a switched cir-
cuit. Incorrect wiring will override IPI safety lockout.
• Refer to Figure 8.3, IPI Wiring Diagram.
• This appliance is equipped with an IntelliFire™ Plus
control valve which operates on a 6 volt/1.5 AMP system.
• Plug the 6 volt transformer plug into the appliance junction
cord to supply power to the unit OR install 4 AA cell
batteries (not included) into the battery pack before use.
NOTICE: Batteries should only be used as a power source
in the event of an emergency power outage. Batteries
should not be used as a primary long-term power source.
Battery polarity must be correct when installing batteries.
When using batteries as a power source, the 6-volt
transformer must be unplugged from the receptacle.
Do not store batteries in the battery pack when the
appliance is powered by the 6 volt transformer connected
to permanent electrical service.
RC300 REMOTE CONTROL
CONTROL
MODULE
GAS VALVE
WIRE HARNESS
GREEN WIRE
ORANGE WIRE
Figure 8.3 IntelliFire™ Plus Wiring Diagram with Remote
PILOT ASSEMBLY
FLAME SENSE IGNITER
RED WIRE
BLACK WIRE
BATTERY PACK
Heat & Glo • SLR-X-AU Installation Manual • 2493-980 Rev B • 12/17
Accessories Requirements
• This appliance ships standard with a remote control.
Wiring for optional Hearth & Home Technologies approved
accessories should be done now to avoid reconstruction.
Follow instructions that come with those accessories.
The junction cord and control module can be accessed
by removing the vanity panel and component heat shield.
The decorative front must be removed to access these
components. See Figure 8.3.
CAUTION! Risk of Overheating! Component heat shield
MUST be installed before operating appliance. Electrical
components will be damaged.
CAUTION! Risk of Overheating! DO NOT remove com-
ponent insulation from top of component heat shield.
Electrical components will be damaged.
Note: For more information regarding the control module
and remote control, please refer to the Owner's Manual.
240V FAN
TRANSFORMER
JUNCTION CORD
AUX MODULE
39