Install Media - Heat & Glo MEZZO-1000-AU Installation Manual

RETAINING BRACKET LOCATION
Figure 11.3 Retaining Bracket Installation - Single-sided Models
RETAINING BRACKET LOCATION
Figure 11.4 Retaining Bracket Installation - See-Through Models
Heat & Glo • MEZZO-1000-AU, MEZZO-1300-AU, MEZZO-1300ST-AU, MEZZO-1600-AU Installation Manual • 2304-970 Rev. D • 3/15
RETAINING BRACKET
DETAIL
RETAINING BRACKET
DETAIL
E. Install Media
A media kit is included with the MEZZO-AU models.
Install rock media according to these instructions.
WARNING! Choking Hazard! Keep media out of reach
of children.
CAUTION! Risk of Burns! The fireplace should be
turned off and cooled before media is installed.
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
Cleaning the Media
During shipment of the media, dust and debris can
accumulate. It is recommended that the media be rinsed
thoroughly with water to remove dust and small
particles. An easy method to clean the media is to place
the media into a pail and rinse thoroughly. Spread the
media out over paper towels and allow the media to dry
before installing them into the fireplace.
INSTALLATION
1. Choose 7 - 10 round pieces of media approximately
1/2 in. (13 mm) in size and set them aside. These will
be used later to conceal the pilot end of the burner.
Reference Figure 1 for choosing round pieces of glass.
WARNING! Risk of Explosion! DO NOT put any flat
media pieces larger than 1/2 in. (13 mm) in diameter
near pilot. Delayed ignition could occur. Use only round
1/2 in. (13 mm) pieces near pilot.
NO
Figure 11.5 Selecting Flat Media for Pilot Cover.
2. The included media placement jig, shown in Figure 2,
MUST be used any time media are placed on the
burner to ensure that none end up in the burner lighting
area. Verify that the media placement jig is correctly
installed in place in the appliance. See Figure 11.7.
YES
51