Model
Parts
Procedures:
7. Use C-ring pliers to release C-ring ψ
10 and take apart the Locking Pin
Assembly, as shown in figure 9.
8. Release 4 M5x10mm Phillips head
screws to take the pedal apart, as
shown in figures 10 and 11)
9. Reverse above steps to resume all
parts. Remember to return the latch
spring and resume adjustable pedal,
Connecting Arm Assembly back on the
Pedal Arm assembly and lock with
Carriage Bolt. Finally, tighten with
5/16" x 15m/m hex head bolt together
with 5/16" x 23 x 1.5T flat washer.
SE578SA
2. Connecting Arm Assembly
Service
Replacing Parts
Rev.
9
1
10
11