Swing Arms - SOLE SE578SA Service Manual

Model
Parts
Procedures：
1. There is a 0.05mm~0.07mm tolerance
for the Handlebar on its shaft for
moving smoothly of the Handlebar so
that a small amount of play is normal.
However, as time lasts there might be
noises, which are caused by parts
wearing out. Applying some grease on
ψ17x 276L shaft on the mast, as shown
in figure 1, might resolve the problem.
2. If the bearing makes noise or gets stuck,
replace this 6003 as shown in figures 2
and 3.
SE578SA
5 Left/Right Swing Arms
Service Troubleshooting
Rev.
1
2
3