Cross Bar Assembly - SOLE SE578SA Service Manual

Model
Parts
Procedures：
1. Follow procedures 2, 3 and 4 to take
apart Connecting Arm, Pedal Arm and
both Side Cases.
2. Take off the Round Disk Cover by
using a tapering stick, as shown in
figure 1.
3. Use 12 mm wrench to release 5/16" x
15m/m hex head bolt with 5/16" x 35 x
1.5T flat washer and then use M6 and
13mm wrenches to release M8x40
socket head cap screws with M8x6.3T
nuts so that the both the Cross Bar and
Round Disk can be taken apart, as
shown in figures 2 and 3.
4. Use Phillips head screwdriver to
release 8pcs of 5x16 tapping screws
with 1/4"x19flat washers to separate
the Cross Bar from Round Disk Cover,
Crank, as shown in figure 4.
SE578SA

5 Cross Bar Assembly

Service Replacing Parts
Rev.
1
2
3
4