External Motion Detection - Zennio ZN1IO-DETEC User Manual

 If motion did not take place during the last T seconds (being T the
detection time), the device will switch to "No Detection" and perform the
corresponding sending, unless the channel is found locked.
 If there was any motion during the last T seconds (being T the detection
time), the device will remain under "Detection", without performing any
sending to the b us.
Forced
DETECTION
DETECTION
is sent to
the bus
Forced states have a higher priority over any other functionality, and are executed
unconditionally with independence of the lock state of the channel and of the state of
the detector.
The parameters and objects involved in this functionality are:
Force state: enables or disables the "[Ix][Ci] Force state" one-bit object.
 Idle Time after Force: sets the time interval during which the channel will
remain in the forced state. The available values are 1 to 255 seconds, 1 to
255 minutes and 1 to 18 hours. Note that forced states ignore the length of
detection and blind time that may have been configured (see section 3.2).

3.2.6 EXTERNAL MOTION DETECTION

This parameter lets enabling or disabling a specific communication object ("[Ix]
External Motion Detection") for the reception of motion detections from external KNX
http://www.zennio.com
Motion
Detection
Time
Idle Time
After Forcing State
NO DETECTION
is sent
to the bus
Figure 19: Forced States (example)
Figure 20. External Motion Detection
Forced
DETECTION
Idle Time
After Forcing State
DETECTION
is sent to
the bus
Technical Support: http://zennioenglish.zendesk.com
Motion Detector
Motion
Detection
Time
NO DETECTION
is sent
to the bus
24