Channels - Zennio ZN1IO-DETEC User Manual

Channels 1-X: activates or deactivates the different virtual detection
channels. Every channel will work independently, which makes it possible to
set different parameters (delays, thresholds, etc.) and different parallel
reactions to the readings sent by a sole physical detector.
Presence Detector: activates or deactivates the presence detection function.

3.2 CHANNELS

Each input allows enabling up to three motion detection channels. These channels
share the same hardware status, i.e., they read the same information about motion,
luminosity and errors in the input. However, each of them can have a different
configuration in relation to:
Motion detection conditions,
Values sent when entering the "Detection" and "No Detection" states.
Channel lock.
Basically, the channel will switch to the "Detection" state when a motion detection
signal is received from the sensor and to the "No Detection" state when such signal is
no longer received.
It will be possible to define a Detection Length and a Blind Time to ensure the
channel remains in the new state for at least a certain time, after which it will listen
again to the signal received from the sensor. The following example illustrates this.
Example: Detection States.
The graph below shows the following succession of events:
At t , the sensor activates the motion signal. The channel switches then to the
1
"Detection" state and sends a "1" through "[Ix][Ci] Detection State", making for
example a lamp turn on.
At t , motion is no longer detected; however the channel remains in "Detection"
2
and starts counting the parameterised Detection Length time (T
http://www.zennio.com Technical Support: http://zennioenglish.zendesk.com
Motion Detector
).
1
12