Table of Contents
Advertisement
3.2.1 DETECTION
These parameters configure what the device should send to the bus when the channel
enters the Detection and No Detection states:
A binary value,
A scene,
A scaling (percentage) value,
An HVAC mode,
Any combination of the above cases.
The same parameters are available for Detection and No Detection (however their
defaults may be different).
Binary Value: enables or disables the sending of a binary value (either "On"
or "Off", according to parameter Value) through object "[Ix] [Ci] Detection
Status (Binary)".
Scene: enables or disables the sending of a scene trigger value (1 to 64,
according to parameter Value) through object "[Ix] [Motion Detector] Scene
Output".
Scaling: enables or disables the sending of a scene trigger value (1 to 64,
according to parameter Value) through object "[Ix] [Ci] Detection Status
(Scaling)".
http://www.zennio.com
Figure 13: "Channel I" – detection function
Technical Support:
Motion Detector
http://zennioenglish.zendesk.com
15
Advertisement
Table of Contents
