Restricting The Sendings Depending On The Luminosity - Zennio ZN1IO-DETEC User Manual

 Lock using the Scene: the channel will switch between the unlocked and
locked states according to the values received through the "[Motion
Sensor] Scene Input" object.
Selecting this option also requires setting the following parameters:

3.2.4 RESTRICTING THE SENDINGS DEPENDING ON THE LUMINOSITY

The following parameters allow restricting the behaviour of the channel according to
the luminosity readings:
http://www.zennio.com
o Send when unlocking: sets a value to be sent to the bus once the
channel switches to the unlocked state, to notify that the detection
process is being resumed. "Nothing", "No detection", "Detection".
The last two correspond respectively to the values (binary, scene,
etc.) set for "Detection" and "No Detection", as explained in 3.2.1.
o Send when locking: analogous to the above parameter; sets the
value to be sent to the bus when the channel becomes locked.
"Nothing", "No detection", "Detection".
Figure 16. Lock using the Scene
o Scene to Unlock: sets the scene number (between 1 and 64) that
will activate the channel.
o Scene to Lock: sets the scene number (between 1 and 64) that will
deactivate the channel.
o Time to Unlock, Initial State, Send when Unlocking and Send
when Locking: these parameters are analogous to those already
described for "Lock using 1-bit object".
Technical Support: http://zennioenglish.zendesk.com
Motion Detector
18