Table of Contents
Advertisement
3 ETS PARAMETERISATION
3.1 INPUT
Once the corresponding input of the device has been configured to work as a motion
detector (please refer to the user manual of the device itself for further details), the
"Configuration" tab shows up. Figure 8 illustrates this.
Moreover, a set of communication objects are available by default:
[Ix] Short Circuit Error: 1-bit object that will notify the KNX bus (by sending
a "1" every 30 seconds) about short-circuit events in the detector wiring or in
the detector itself. Once solved, the value "0" will be sent (once) through the
same object.
[Ix] Open Circuit Error: 1-bit object that will notify the KNX bus (by sending
the value "1" every 30 seconds) about open-circuit events in the detector
wiring or in the detector itself. Once solved, the value "0" will be sent (once)
through the same object.
[Motion Sensor] Scene Input: 1-byte object through which it will be possible
to receive scene values (0 – 63, both included) from the bus.
[Motion Sensor] Scene Input: 1-byte object through which it will be possible
to send scene values (0 – 63, both included) to the bus.
Note: object names may differ slightly depending on the input port where the motion
detector has been connected.
The following parameters are available in the Configuration tab:
http://www.zennio.com
Figure 8. "Configuration" Tab
Technical Support:
Motion Detector
http://zennioenglish.zendesk.com
10
Advertisement
Table of Contents
