Models And Supported Devices - Zennio ZN1IO-DETEC User Manual

1.2 MODELS AND SUPPORTED DEVICES

The Zennio Motion Detector is marketed as an optional accessory for the variety of
Zennio devices equipped with inputs and whose application program is specifically
compatible with the Zennio motion detector.
The user manuals of the Zennio devices specifically make reference to this
functionality, so please refer to them to confirm whether a particular device is
compatible with the motion detector or not. Moreover, the behaviour and the options of
the motion detection function may differ slightly depending on the Zennio device it is
connected to. Therefore, the user manual of the motion detector has been
particularised for each device. To access the documentation, it is highly recommended
to make use of the links provided at the Zennio homepage (www.zennio.com) within
the specific section of the particular device being configured.
On the other hand, the Zennio motion detector is marketed under different reference
numbers:
Type A:
ZN1IO-DETEC,
ZN1IO-DETEC-N.
Type A and Type B (switchable):
ZN1IO-DETEC-P.
ZN1IO-DETEC-X (identical to the above one, but with no luminosity sensor).
Note that ZN1IO-DETEC-P and ZN1IO-DETEC-X can work under two different voltage
modes, noted as "Type A" and "Type B". This is possible by means of a specific mode
selection micro-switch (see section 2.1), which should be configured according to the
particular Zennio device the detector is being connected to.
For information about the type (A or B) that applies to each Zennio device, please refer
to its Datasheet (available at www.zennio.com) or contact the Zennio Technical
Support.
http://www.zennio.com Technical Support: http://zennioenglish.zendesk.com
Motion Detector
5