Connecting The Multifunction Relay - SMA SUNNY TRIPOWER CORE1 Operating Manual

SMA Solar Technology AG
Procedure:
1. Release and remove all DC connectors. To do this,
insert a flat-blade screwdriver or an angled
screwdriver (blade width 3.5 mm) into one of the
slide slots and pull the DC connectors out in a
downward direction. Do not pull on the cable.
2. Remove the DC connector swivel nut.
3. Unlock the DC connector. To do this, insert a flat-
blade screwdriver (blade width: 3.5 mm) into the
side catch mechanism and pry the catch mechanism
open.
4. Carefully pull the DC connector apart.
5. Release the clamping bracket. To do so, insert a flat-
blade screwdriver (blade width: 3.5 mm) into the
clamping bracket and pry the clamping bracket
open.
6. Remove the cable.
6.5

Connecting the Multifunction Relay

6.5.1 Procedure for connecting the multifunction relay
Procedure
1. Select for which operating mode you would like to use the
multifunction relay.
Operating manual
6 Electrical Connection
1
2
+
3
+
1
1
+
See
Section 6.5.2, page 36
STP50-40-BE-en-12
2
2
35