Commodore C-NET 128 v7.0 User Manual page 96

will be version 2.0.
been cleaned up so the programs run faster.
been included as explained under flags in section 18.8.
****NOTE****
You do not have to run the pauq routines for v1.9 to run properly.
The one time
connection long distance.
bit on long distance charges.
Another nice touch with Multi-Net v1.9, is that everything is done in a
windows environment.
happening while the board goes through it's network routine.
You can now send program files over the modem to another node.
'NX' command to do this.
of the programs down.
long distance charges.
The network routines are the same as with Multi-Net v1.5 with the exception
that the very first and last thing the board does, is either un-pauq or
pauq the files.
Another nice touch to Multi-Net v1.9, is the ability for the sysop to abort
a callout. If you have to abort a callout, just hit the 'ESC' key.
'ESC' key must be pressed for each of the three tries that the board will
try to make before quitting the callout.
Multi-Net v1.9 works faster as well as in prg.net-trans, the computer quits
looking for connections after it sees an up arrow (^) in the file
net.connections.
through ALL the nodes before deciding there was only one or two
connections.
19.17 ADDED PROGRAMS
There have been a few P-files added to the main files that can assist a
sysop in the performance of his duties.
added is called prg.net-dist.
networked message bases, and send a copy of your connections to a specific
networked board.
that carries and compiles a master list of all networked message bases and
who carries which ones.
Outpost to change the message bases that you carry.
a copy of your network bases to that sysop.
The program works this way: First off, you run the program, then you set
the parameters by using the 'P' command.
you want to send the file to.
network node number is '11'. Then you use the 'S' command to send the file.
That is all there is to it.
Another file that has been added is prg.net-easy.
you to check and fix any problems that may arise with your net.Subs file.
Any time that you make a change to your networked bases, you should run
prg.net-easy to double check that there has not been any corruption of your
net.Subs file. The program is menu driven and self-explanatory.
v1.9 is the same as v1.5, however, the coding has
that you should use the pauq routines is if you call your
By sending only one file, you save a little
It also makes it easier for the sysop to see what is
Generally, other nodes ask that you keep the size
REMEMBER that the other nodes are paying for the
Other than that, everything is done in the same manner.
With version 1.5, the computer would continue to look
This program file will look at your
At the present time, The Northern Outpost is the board
That does not mean that you contact The Northern
The handle you use is 'sysop' and the
Easy as pie.
As well, pauq routines have
One of the files that have been
It only means you send
That will be the person and board
This program will allow
You use the
The