Commodore C-NET 128 v7.0 User Manual page 91

levels. One note here, is that you can call the message subs anything you
wish on your system.
Information. You DO NOT have to call each message sub the same as the
network name.
On my system, I call the CNET sub CNET Updates.
keep you message subs on another LU or drive other than your system drive.
The reason for this is that the message subs use relative files, and
sometimes they can expand into your program files and corrupt your system.
Another reason is that sometimes you can get a corrupt subs file from your
connection, and this in turn can corrupt your system files.
Remember this when you are setting up the location (drive and device
numbers). The following are the items that you edit when editing your
networked message sub along with the commands:
B Board Name:
on your system.
L Location:
subs
message subs on
files. Occasionally the
corrupted and therefore corrupt your system
M Max Lines: This is the amount of maximum lines that users are allowed
to use
T Type of board:
networked
P Password:
E Entry Access:
W Write Access:
Y Youngest Age:
O Oldest Age:
F Flags:
I Inactive days:
N Net Name:
finds
from your connections.
C Connection 1-6:This is where you put in the numerical node number you
wish to
you will receive new
'(board
you answer 'Y' and
connection.
For example, you can call the C-NET sub C-net
This is the name you wish to call the message sub
This is the LU or drive that you wish to have your message
on. It is recommended that you do not put your
in the message bases.
This is where you use the '4' to make the board a
board.
This is the same as the local message bases.
Once again, the same as the local message bases.
I repeat again, same as local bases.
Been covered before.
Covered before.
Covered under chapter 3.5.
Covered in chapter 3.5.
Okay, this is IMPORTANT.
given to you by your connection.
where to put the messages that it receives
have this message sub sent to, as well as who
messages from. You will be prompted if the connection is
name).
It is recommended that you
the same LU or drive as your system
relative files can get
The net name MUST be exactly as
If it is the correct board name, then
that board will be installed as the
files.
This is how Multi-Net