Commodore C-NET 128 v7.0 User Manual page 41

The following are other commands that can be used at all levels:
AG This command allows the user to see a graph of system activity
by showing a percentage of use during the different time of day.
Some users use this graph as an indication as to when the
system is slowest, so they can call in and not interfere with
other users.
BT This command allows a baud rate change for 2400-baud callers
only.
ID Remote sysops must use this to gain maintenance access.
feature is also password protected.
'CNET'.
However, it is
down so it does not get lost.
TC This command calls up the caller log for the current day.
command will show who has called to the system since the last
auto-maintenance routine.
C This is the command for a real time chat mode with the sysop.
RE This command allows the user to re-logon without first
disconnecting from the system.
the user groups, then the user can continue his call without
disconnecting.
user must log off the system and call back to continue.
QR This command allows the user to Quick Read new messages in all
the joined message bases.
QS This command allows the user to Quick Scan new files in the U/D
section.
W This command allows the user to see and add graffiti to the
Wall.
of class.
X If a sysop has the call-back verifier turned on, this command
will allow new users to have the system call them back to
receive higher access.
some of the files that allow a default higher access level to a
new user if the user meets certain criteria.
7.24 SUMMARY OF COMMANDS
For a summary of commands that are available at any given command level, a
user may enter a question mark ('?') which displays the appropriate menu
file from the system disk.
7.25 CONTROL CHARACTERS
There are several control characters that are useful throughout the system.
They are the following:
CONTROL S
mode,
packages, the
Any key may be used to re-
CONTROL V
reprinting it. If
interference, verifying the input line
correct input.
CONTROL W - may be used to delete an entire word on the current input
line.
CONTROL X
This password can be changed by the sysop as well.
recommended that the new password be written
However, if the command is turned off, then the
All MCI commands can be used on the wall to add a touch
- may be used to pause the output from C-NET.
and when using many Commodore terminal
- may be used to 'verify' the current input line by
- may be used to cancel the current input line entirely,
The default password is
If this command is turned on in
Some modifications have been made to
CLR/HOME key may be used instead.
start the output.
there is a lot of 'line noise'
This
This
In local
helps to insure