Commodore C-NET 128 v7.0 User Manual page 72

right, center,
left justify text (move to
justify text (move to the right border), 'C'
justify text ( move to the center of the screen), 'P' must be
pack text (remove all extra spaces between words), or 'E' must be hit to
expand text (insert spaces between words to align text along both the left
and right margins).
16.8 SPECIFYING A LINE RANGE
For many editor commands, such as deleting, editing, justification,
replacing, reading, and listing, a line range can be specified.
how it's done:
16.9 VT-100 VISUAL EDITOR
A very powerful feature of the C-NET 128 is its VT-100 visual editor
implementation.
used in local mode, but may only be used on-line if the caller is using a
DEC VT-100 compatible terminal emulator program.
are available for most personal computers.
cursor movement is possible throughout the document.
control code commands available in the visual editor.
Control X Exit the visual editor mode and return to the standard line
editor.
Control K Kill the current line and pull all following text up one line.
Control L Insert a blank line at the current cursor position moving all
following text
Control I Insert a single-space at the current cursor position.
INS/DEL from
Control D Delete a character at the current cursor position.
pull text into the
Control H Backspace and pull text back one space, deleting the preceding
character.
local mode.)
Control R Reprints the current line only to verify its contents or to
mend damage
Control S Clear and re-print the entire screen from the beginning of the
text buffer.
16.10 EXTRA EDITOR COMMANDS
expand, and pack.
the left border), 'R' must be hit to right
x line x only
,y from beginning to line y
x, from line x to end
x,y from line x to line y
x;y,z line x and line y to line z
w,x;y,z
'.V' is used to enter the visual editor.
down one line.
local mode)
cursor.
(Most terminals have a BACKSPACE key or INS/DEL from
caused by line noise.
After '.J' is used, 'L' must be hit to
lines w to x and lines y to z
Such terminal emulators
Once in the visual editor, full
(Hex $FF DEL may be used from remote)
must be used to center
Here is
It may always be
There are several
They are as follows:
(Shift
That is,
hit to