Extech Instruments CO210 User Manual page 5

P1. CO ALARM: HIGH ALARM
3 2
P1. is used for setting the CO
3
will be blinking on the display.
Press the LOG/▲or MIN/MAX▼ button to increase or decrease the value. Each press adjusts in
100ppm increments. The alarm range is 1000 to 5000ppm.
When the value has been set, press the SET button to confirm the limit and to proceed to P2.0
ress the ESC button to return to P1.
p
P2. TEMPERATURE SCALE
0
Press the LOG/▲ button in P1.
Press the SET button to go into the P2.1setting mode. The °C or °F will blink.
Press the LOG/▲button to change the units. Press the SET button to confirm the setting or press
the ESC button to exit without saving and return to P2.
P3. REAL TIME CLOCK
0
Press the LOG/▲ button in P1.
button and the meter goes into P3.
press the LOG/▲ button or the MIN/MAX▼ button. Press the SET button to save the setting and
then enter P3. or press the ESC button return to P3.
2
Press the LOG/▲ button P3.
month, press the LOG/▲ button or the MIN/MAX▼ button. Press the SET button to save the setting
and then enter P3.
Repeat as above to finish the setting of P3.
www.ponpe.com
upper limit for the BEEPER ALARM level. The current set value
2
.
0
mode to access P2.
0
twice to access P3.
0
with blinking year in the lower left display. To change the year,
1
to access P3.
1
or press the ESC button return to P3.
3
CO
2
for setting the temperature scale.
0
.
0
for setting up real time clock. Press the SET
0
without saving the setting.
0
. The current month setting will blink. To change the
2
without saving the setting.
0
(Date), P3. (Hour) and P3.
3 4
5
(Minute)
5
CO210-en-EU_V1.2 8/14
contact:
sale@ponpe.com
or