Maintenance Procedures; Engine Oil - Sea-doo GTXPRO 130 Series Operator's Manual

MAINTENANCE PROCEDURES

This section includes instructions for
basic maintenance procedures.
WARNING
Turn off the engine and follow
these maintenance procedures
when performing maintenance.
If you do not follow proper main-
tenance procedures you can be
injured by hot parts, moving parts,
electricity, chemicals or other haz-
ards.
WARNING
Should removal of a locking device
(e.g. lock tabs, self-locking fasten-
ers, etc.) be required, always re-
place with a new one.
NOTICE
Never leave any object,
rag, tool, etc., in the engine com-
partment or in the bilge.

Engine Oil

Recommended Engine Oil
Rotax ® engines were developed and
validated using the XPS™ oil. BRP rec-
ommends the use of its XPS engine oil
or an equivalent at all time. Do not add
any additives to the recommended en-
gine oil. Damages caused by the use
of an oil not suitable for the engine or
by adding of an additives may not be
covered by the BRP Limited Warranty.
______________
83
XPS RECOMMENDED ENGINE OIL
4T 5W40 Synthetic blend oil
If THE RECOMMENDED XPS
ENGINE OIL IS NOT AVAILABLE
Use a 5W40 4-stroke SAE
synthetic engine oil meeting
or exceeding the following
lubricant industry specifications.
Always check the API service
label certification on the oil
container, it must contain at least
one of the indicated standards.
API service classification SJ,
SL, SM or SN
Do not add any oil additives to the
recommended engine oil. Damages
caused by the use of an oil not suitable
for the engine or by adding of an oil ad-
ditives may not be covered by the BRP
Limited Warranty.
Engine Oil Level
NOTICE
Operating
with an improper level may severely
damage engine.
CAUTION Many components
in the engine compartment may be
very hot. Direct contact may result
in skin burn.
Oil level can be checked with water-
craft either in or out of water.
If Watercraft is Out of the Water
NOTICE
Watercraft must be level.
CAUTION When operating the
engine while the watercraft is out of
water, the heat exchanger in the ride
plate may become very hot. Avoid
any contact with the ride plate as
burns may occur.
1. Raise trailer tow pole, then block in
position when bumper rail is level.
the engine