Checking The Rubber Grip - KTM 250 XC-W 2018 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.42
90
E00841-10

Checking the rubber grip

401197-01
K00547-10
Main work
–
Check throttle cable routing.
The throttle cable must be routed behind the handle-
bar, on the right of the frame, and to the carburetor. The
throttle cable must be secured behind the fuel tank con-
tact area rubber band.
» If the throttle cable routing is not as specified:
–
Correct throttle cable routing.
Finishing work
–
Install the fuel tank. (
–
Mount the seat. ( p. 76)
–
Check the rubber grips on the handlebar for damage, wear,
and looseness.
Info
The rubber grips are vulcanized onto a sleeve on the
left and onto the handle tube of the throttle grip on the
right. The left sleeve is clamped onto the handlebar.
The rubber grip can only be replaced with the sleeve or
the throttle tube.
» If a rubber grip is damaged or worn:
–
Change the rubber grip.
–
Check that screw 1 is firmly seated.
Guideline
Screw, fixed M4
grip
A
Diamond must be located at the top.
p. 82)
5 Nm (3.7 lbf ft)
Loctite ® 243™