KTM 250 XC-W 2018 Owner's Manual page 140

17 TUNING THE ENGINE
138
–
Remove cap
and spring insert
–
Pull both springs off of the spring insert.
B00056-11
–
Mount the required auxiliary spring (
adjusting spring
cover.
Auxiliary spring with yellow marking (54637072300)
Auxiliary spring with green marking (54837072100)
Auxiliary spring with red marking (54837072000)
The recess in spring insert
E00365-10
Info
Screw
engine characteristic.
–
Check the O-ring in the cap.
–
Position the cap.
–
Mount and tighten the screws.
Guideline
Screw, exhaust
control cover
2 3
, adjusting spring , auxiliary spring
5
from the clutch cover.
p. 137)
3
and position them together in the clutch
5
engages in the angle lever.
6
must not be turned as this would worsen the
M5 4 Nm (3 lbf ft)
4
,
4
and
Loctite ® 222™