Table of Contents
Advertisement
12 SERVICE WORK ON THE CHASSIS
12.12
70
E00375-12
Installing the lower triple clamp
B01218-10
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front
M8
brake caliper
–
Mount the cable tie(s).
–
Position the brake line, wiring harness, and clamp. Mount and
bk
tighten screws
.
Finishing work
–
Mount the handlebar cushion.
–
Install front fender. (
p. 74)
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check that the wiring harness, throttle cables, and brake and
clutch lines can move freely and are routed correctly.
–
Check the play of the steering head bearing. (
–
Remove the motorcycle from the lift stand. (
–
Check the headlight setting. (
(All Six Days models)
Main work
–
Clean the bearing and sealing elements, check for damage,
and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the
upper steering head bearing.
–
Check whether upper steering head seal
tioned.
–
2
Mount protective ring
25 Nm (18.4 lbf ft)
Loctite
(
p. 108)
p. 120)
p. 72)
p. 63)
p. 122)
p. 167)
1
is correctly posi-
3
and O-ring
.
9
.
®
243™
Advertisement
Table of Contents
