Preparation; Application And Inhalation - Vapormed MIGHTY MEDIC Instructions For Use Manual

7. THE USE OF HEMP FLOWERS ( CANNABIS FLOS )
Reference values for hemp flowers with a cannabinoid content of e.g. 6% THC
and 7,5% CBD:
Amount of hemp Cannabinoid content
flowers (Dosing of the hemp flower
Capsule content) portion
THC: 3 mg
50 mg
CBD: approx. 3,2 mg
THC: 6 mg
100 mg
CBD: approx. 7,5 mg
THC: 9 mg
150 mg
CBD: approx. 11 mg
In order to reach these values, inhalation must be continued until there is no
aerosol (vapor) recognizable when exhaling. The Dosing Capsule's content is
then depleted.

7.1. Preparation

Make sure to use the Mouth-
piece only with attached Lip
Piece before every operation
(see Chapter 8.1. "Disposable Lip
Piece for Hygienic Use", page 29).
Remove the Cooling Unit and insert
the prepared Dosing Capsule (see
Chapter 6. "Dosing Capsule with
Magazine", page 22) or fill the Fill-
ing Chaber directly.
Mount the Cooling Unit on the
MIGHTY MEDIC Vaporizer and heat
up to 180°C (356°F). This ensures
that both the Filling Chamber and the
Dosing Capsule are preheated and
Cannabinoid
Cannabinoid con-
content in blood
tent in the aerosol
stream (systemic
(vapor)
bioavailability)
after inhalation
approx. 1,5 mg approx. 1 mg
approx. 1,6 mg approx. 1,1 mg
approx. 3 mg approx. 2 mg
approx. 3,7 mg approx. 2,3 mg
approx. 4,5 mg approx. 3 mg
approx. 5,5 mg approx. 3,5 mg
the vaporizing can begin as soon as
the heating process is completed.
Caution! Hot surface!
After using the MIGHTY MEDIC Va-
porizer, do not touch the Filling Cham-
ber or the Dosing Capsule until they
have cooled down again.

7.2. Application and Inhalation

It is recommended to begin inhalation
at a temperature of 180°C (356°F).
Once the MIGHTY MEDIC Vapor-
izer has reached the set temperature
26
7. THE USE OF HEMP FLOWERS ( CANNABIS FLOS )
(180°C (356°F)) (set and actual tem-
peratures are the same, also signaled
by a short double vibration) and the
Mouthpiece with Lip Piece is folded
out, the inhaling process can begin.
Using the MIGHTY MEDIC Vaporizer
If the vapor decreases when exhaling
after some draws, set the temperature
to 210°C (410°F). As soon as there is
no vapor recognizable when exhaling
at 210°C (410°F), the Dosing Capsule
is depleted and the inhalation pro-
cess has ended.
Breathing Technique
Take the Mouthpiece with Lip Piece
between the lips, and inhale slowly
and evenly for several seconds.
Inhale only half of air you can normally
manage. Hold your breath for a few
seconds and exhale slowly.
We recommend consciously concen-
trating on your inhalation. The can-
nabinoid aerosol is absorbed by the
alveoli and into the bloodstream. The
onset of the effect takes approx. 1-2
min.
End of Inhalation
After inhalation, turn off the MIGHTY
MEDIC Vaporizer. To do this, press
the orange ON/OFF switch for at
least half a second. The Vaporizer
acknowledges the switching off with a
short vibration.
Remove the Lip Piece and dispose of
it in the residual waste.
Turn the Cooling Unit with a 90° ro-
tation counterclockwise in order to
remove it from the MIGHTY MEDIC
Vaporizer remove the Dosing Capsule
from the Filling Chamber, open it and
dispose of the used hemp flowers in
the compost or residual waste.
Caution! Hot surface!
After using the MIGHTY MEDIC Va-
porizer, do not touch the Filling Cham-
ber or the Dosing Capsule until they
have cooled down again.
Pull the power adapter (if it is used)
from the socket and disconnect from
the Vaporizer. Allow the Vaporizer
and the power adapter to cool down
before they are packed away.
27