Application And Operation; Charging The Battery - Vapormed MIGHTY MEDIC Instructions For Use Manual

5. COMMISSIONING AND OPER ATION OF THE
M IGHTY M EDIC VAPORIZER

5.3. Application and Operation

The MIGHTY MEDIC Vapor-
izer was developed for vapor-
izing the cannabinoids listed
in the instructions.
Any other use is inappropriate and po-
tentially dangerous.
The user should always follow the
instructions listed here for use and
maintenance.
If you have any concerns, or if there
are any problems immediately switch
off the MIGHTY MEDIC Vaporizer and
pull the power adapter cord, if used,
from the socket. Do not try to remedy
the defect yourself. Contact our Ser-
vice Center directly.
After using the Vaporizer and power
adapter, allow them to cool down be-
fore placing them in storage.
Do not leave the device unat-
tended during operation.
Place the MIGHTY MEDIC
Vaporizer only on a hard, heat-resist-
ant, flat, stable surface, never on soft
surfaces or flammable material.
Check whether the power supply volt-
age corresponds to the voltage rating
listed on the power adapter. The pow-
er adapter cord and power adapter
must be in perfect condition. Connect
the power adapter only to a properly
installed socket.
The manufacturer will not bear any
responsibility whatsoever if this acci-
dent prevention measure is not taken.
Please unplug the power adapter from
the mains socket to completely dis-
connect from the mains power supply.

5.4. Charging the Battery

Explanation of the battery charging
display:
The battery charging display shows
a battery symbol with six fields indi-
cating the charging status. If the bat-
tery is almost discharged, the battery
frame starts to flash; if fully charged,
the frame and all six fields are visible.
The number of status fields visible
depends on the extent of the battery
charge.
Battery charging display
Check the housings of the
MIGHTY MEDIC Vaporizer
and the power adapter for
signs of damage each time before us-
ing or charing. The Vaporizer may not
be charged and neither Vaporizer nor
power adapter used if these are dam-
aged.
18
5. COMMISSIONING AND OPER ATION OF THE
M IGHTY M EDIC VAPORIZER
The battery charge of the new product
has a level of up to 80%. Fully charge
before using for the first time.
The charging time for the battery de-
pends on how old it is and how high
the charge is on starting; it takes
about two hours if the battery is com-
pletely discharged.
Connect the power adapter to the
charging socket of the MIGHTY MED-
IC Vaporizer and then plug into a suit-
able power socket.
Note: When the power adapter is
plugged into the mains, the dis-
play lights up for a moment and the
MIGHTY MEDIC Vaporizer vibrates
for a short time. This is a functional
check and indicates that the charging
operation has started.
The battery charging display lights up
and starts to flash, i.e. the battery is
being charged. As soon as the battery
is fully charged, the battery charging
display stops flashing and indicates
the charge level (full = all six fields).
Once the charging operation is com-
plete, first disconnect the power
adapter from the mains socket and
then unplug from the MIGHTY MEDIC
Vaporizer.
Connecting the MIGHTY MEDIC Vaporizer
using the power adapter
Batteries are specially as-
sembled consumable items
that can only be replaced by
our Service Center when the MIGHTY
MEDIC Vaporizer is sent in to them.
Any attempt by the customer to re-
place the battery by him/herself is
potentially dangerous and leads to
loss of any claims under the warranty
and exempts Storz & Bickel from any
liability.
19