Memory Function / Sensors / Auto Detection
The air puriﬁ er performs automatic operation by detecting room air contamination using the "Odor Sensor" and "Dust
During the ﬁ rst 3 minutes after the power is turned on, the unit will check the air condition of the room.
The puriﬁ er operates even while it checks the air condition of the room.
During this time, the "Air Sensor" ﬂ ashes green.
After checking the air condition, the "Air Sensor" will display the room air contamination using the "Odor Sensor"
and the "Dust Sensor".
If you plug in the power cord in an environment containing contaminated air, the sensitivity of the sensor may be
To clean the air of the room, operate in "High" or "Max". Or open a window and unplug the power cord from the AC
outlet when ambient air is clean and plug it back in after 10 seconds.
Adjusting Sensory Sensitivity Setting
Sensitivity of the "Odor Sensor" and "Dust Sensor" which performs automatic switching of airﬂ ow rate can be ad-
justed in 3-step fashion.
You can adjust the sensor sensitivity setting as desired.
The "Odor Sensor" and "Dust Sensor" are similarly adjusted.
The current sensitivity is indicated and displayed. (Factory setting is
While the sensitivity is being displayed (about 10 seconds),
The sensitivity display will change from
Furthermore, when switching sensitivity, repeat procedure
When repeating, the sensitivity display will switch like this
About 10 seconds after the sensitivity display has been switched, it will disappear and the selected sensor sensitivity will be set.
Switching the sensor sensitivity is not supported in the "PM2.5 Sensor" cycle.
for about 3 seconds, while pressing
for about 3 seconds