Operation; Starting Operation; Switching Airfl Ow Rate - Hitachi EP-NZG70J Instruction Manual

Operation

Starting Operation

Securely insert the power plug to the outlet
1
2
Press the
Operation will start, and indicator
will light up.
Pressing the
while the unit is operating will
dim the indicator and stop the
operation of the unit.
 "Air Purify" mode is set as a factory default.
 From the second use onward, the memory function enables operation based on the saved status.
 For power saving, the display and operation panel other than the notifi cation display and the air sensor will turn off
approximately one minute after the unit stops operating.
Standby Power Consumption
 As long as the power plug is inserted in the outlet, the unit consumes approximately 2W of power, even if the unit
is not in use.
(Unplug from the outlet if the unit will not be used for an extended period of time.)
Switching Airfl ow Rate
 Each time Air
flow
Auto
EP-NZG70J_EN.indd 17 EP-NZG70J_EN.indd 17
power button
power button
button is pressed while the unit is operating, the mode switches in the following order.
Max "Silent"
After all indicators have light up at once,
"Auto" will light up.
For the first 3 minutes, the unit will
check and store the condition of the
room air.
During that time, the "Air Sensor" will
flash a green light.
Power button
Airflow
"Medium" "High"
Blinking
(P.E-21)
...
Auto
E-17
6/30/2017 10:32:30 6/30/2017 10:32:30