Preparations For Operation; Setting Filter In Unit - Hitachi EP-NZG70J Instruction Manual

Table of Contents

Advertisement

Preparations for Operation

CAUTION
 Movement with casters should be done slowly. The movement is only in sideways direction. (To prevent from falling)
 No cleaning effect will be experienced if the fi lter is set without detaching the plastic cover. It will also cause unit failure.
 Do not tip over or tilt the unit.

Setting Filter in Unit

 Setting procedure is the same with fi lter replacement. (Use only genuine Hitachi Air Purifi er fi lters.)
Remove rear panel and pre-filter
1
Place the unit on a flat and stable location.
Hold the bottom part of the rear panel
(2 locations), pull it out gently, and shift
slightly upward to remove it.
Slide the switch upwards (2 locations)
to release the lock.
4
Remove the pre-filter.
Remove the filter
2
Remove the filter from the
unit.
Remove the filter from the
plastic packaging.
Install the filter to the unit
3
CAUTION
Do not put excessive force and deform
the filter.
E-14
EP-NZG70J_EN.indd 14
EP-NZG70J_EN.indd 14
Switch
Pre-filter
Filter
Set the filter so that you can see the label
Slide the switch upward.
Plastic packaging
Filter
Filter
6/30/2017 10:32:30
6/30/2017 10:32:30

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EP-NZG70J and is the answer not in the manual?

Questions and answers

Table of Contents