Table of Contents
Advertisement
Using the Control on Purifi er
Memory Function / Sensors / Auto Detection
When you stop the operation and then restart, the purifi er will resume the operation status before shutdown.
If you operate the purifi er for approx. 5 seconds or longer, the operation status will be stored in memory.
(If you stop the operation within less than 5 seconds, the operation status will not be stored in memory.)
Even if you unplug the power cord, the operation status will be stored in memory. However, the airfl ow rate is
automatically set to "Auto".
Level of air contamination detected by the odor sensor, dust sensor is shown by the way the indicator is activated.
Indicator action
Contamination level: Clean
Note
You can adjust the air sensor, dust sensor sensitivity setting as desired.
In case the purifi er is installed in a place where air contamination is hard to detect
or in case the sensor itself is not clean, the indicator action may not change.
The sensor detects odor in air such as cigarette smoke or odor of pet animals.
Even when you feel the air is clean, the purifier may continue the operation if the
odor sensor finds any gas component not removed by the filter.
Any of the following may also be detected by the odor sensor.
Combustion gas from heating appliance, alcohol, odor of perfumes or cosmetics
used in beauty parlor or aesthetic salon, sprays, vapor, abrupt temperature
change, etc.
E-14
Air
Sensor
Memory Function
Air Sensor
: Lit in green
Odor Sensor
On/Off
Press
Operation starts.
Every time you press
mode switches in the following sequence so that you
can choose a desired mode or stop.
Air
Pollen
Purify
Deodorization
The airflow rate is set to "Auto" by switching the
operation mode.
Blink in green
Contaminated
P.E-16
button.
On/Off
button, the operation
Skin
Strong
Humidify
Moisturize
Skin
Moisturize
Timer(4hrs)
Clean
Max(Blinking)
Humidifying
Filter
P.E-25
Odor sensor
Off
Air
Sensor
Hide quick links:
Advertisement
Table of Contents
