Table of Contents
Advertisement
Using the Control on Unit
Memory Function / Sensors / Auto Detection
When you stop operation and then restart, the purifier will resume the operation that was running before shutdown.
If you operate the Purifier for approximately 5 seconds or longer, the operation status will be stored in memory.
(If you stop operation before 5 seconds have elapsed, the operation status will not be stored in memory.)
Even if you unplug the power cord, the operation status will be stored in memory. However, the airflow rate is
automatically set to "Auto".
Level of air contamination detected by the odor sensor and dust sensor is shown by the way the indicator is activated.
Indicator action
Contamination level: Clean
Note
You can adjust the air sensor and dust sensor sensitivity setting as desired.
In case the purifier is installed in a location where air contamination is difficult to
detect or in case the sensor itself is not clean, the indicator action may not change.
The sensor detects odors in the air such as cigarette smoke or animal odors.
Even if you think the air is clean, the unit may continue the operation if the odor
sensor detects any gas component that has not been removed by the filter.
Any of the following may also be detected by the odor sensor.
Combustion gases from heating appliances, alcohol, odor of perfumes or cos-
metics used in beauty parlors or aesthetic salons, sprays, vapors, abrupt tem-
perature changes, etc.
E-18
Ai r
Sensor
r
Memory Function
Air Sensor
: Light up in green
Odor Sensor
Press
Operation starts.
Every time you press the
mode switches in the following sequence so that you
can choose a desired mode or stop.
Air
Pollen
Purify
Deodorization
The airflow rate is set to "Auto" by switching the
operation mode.
Blink in green
Contaminated
button.
button, the operation
Skin
Strong
Humidify
Moisturize
Skin
Moisturize
Timer(4hrs)
Clean
Max(Blinking)
Humidifying
P.E-20
Filter
P.E-29
Odor sensor
Off
Ai r
Sensor
r
Hide quick links:
Advertisement
Table of Contents
