Cleaning; Pre-Fi Lter, Filter - Hitachi EP-NZG70J Instruction Manual

Cleaning

 Do not stop operation by unplugging the power plug.
Otherwise, it may cause fi re, electric shock or unit failure.
 Do not splash water on the unit. Doing so may cause a unit failure.
 Do not use volatile solvents, such as gasoline, thinner, benzene, wax, kerosene, alcohol, etc. or polishing powder, or deter-
gent (used for kitchen or laundry). Such chemicals could cause deformation, discoloration, damage or removal of print labels.
 When using a chemically treated cloth, follow safety instructions.
 Do not use a dryer or heater to dry the unit. Heating could cause deformation, discoloration, damage or removal of print labels.
 Lay a soft cloth or similar material beneath and around the purifi er body to protect the fl oor against scratches
and from getting wet.
 Do not tilt or tip over the unit.
Pre-fi lter, Filter
Clean the pre-fi lter and fi lter frequently because dust and dirt get on them.
1
Check if the operation has stopped before removing the power plug from the socket
While operating, press the
2
Remove the rear panel, pre-filter and filter
Cleaning
3
Pre-filter
Remove dust using a vacuum cleaner.
Lightly clean using the nozzle brush of the vacuum cleaner
and vacuum the dust.
Remove dirt by washing with water.
If it is extremely dirty, wash it with water and a soft sponge
without using excessive force. Drain well and let it dry in a
well-ventilated area away from direct sunlight.
CAUTION
The stainless coating of the surface will peel off if it is
rubbed with the floor nozzle of a vacuum cleaner or a scrub.
Do not use detergent (kitchen or laundry use) for cleaning.
Filter
The dust on the filter may emit an odor.
Be sure to remove the dust using a vacuum cleaner or the like.
Lightly clean using the nozzle brush of the vacuum cleaner and
vacuum the dust.
CAUTION
Do not put excessive force and deform the filter.
4
Attach the filter
5
Attach the pre-filter and rear panel to the unit
 The pre-fi lter is a consumable part.
When damaged pre-fi lter needs to be replaced, purchase the replacement part (Part No. EP-HG50-004).
EP-NZG70J_EN.indd 23 EP-NZG70J_EN.indd 23
WARNING
CAUTION
power button and stop operation.
(P.E-14)
(P.E-14)
Nozzle brush
Pre-filter
Note: Clean the back face as well.
Filter
(Do not wash with water)
Nozzle brush
(P.E-15)
(P.E-29)
E-23
6/30/2017 10:32:31 6/30/2017 10:32:31