Preparations For Operation; Setting Filter In Unit - Hitachi EP-PF120J Instruction Manual

Preparations for Operation

CAUTION
 Movement with casters should be done slowly. The movement is only in sideways direction. (To prevent from falling)
 No cleaning effect will be experienced if the fi lter is set without detaching the plastic packaging. It will also cause unit failure.
 Do not tip over or tilt the unit.

Setting Filter in Unit

 Setting procedure is the same with fi lter replacement. (Use only genuine Hitachi Air Purifi er fi lters.)
Remove front panel and pre-filter
1
Place the unit on a flat and stable location.
While supporting the unit, use your thumbs
to gently pull the upper left and right parts of
the front panel in the direction of the arrow.
When the front panel is fully open, gently lift
it in the direction of the arrow.
*The pre-filter also detaches when the front
panel is removed.
Remove the filters
2
(Dust filter and deodorizing filter)
Remove the dust filter from the unit.
Remove the deodorizing filter from the unit.
Remove the filters from the Plastic
packaging.
Install the deodorizing filter to the unit
3
Set the filter on the deodorizing filter setting position.
CAUTION
Do not put excessive force and deform
the filter.
E-14
EP-PF120J_EN.indd 14 EP-PF120J_EN.indd 14
CAUTION
Do not forcefully pull the front panel.
The unit will fall over and cause injury.
Front panel
Front panel
Plastic packaging
Deodorizing filter
Deodorizing filter
Dust filter
Deodorizing filter set position
2/11/2019 3:36:22 PM 2/11/2019 3:36:22 PM