Hybrid Networking Of Zxa10 S 300 And Zxa10 & Zxe10 - Zte ZXA10 S300 Technical Manual

ZXA10 S300 (V1.1) Integrated Access Service Dispatching Unit Technical Manual
78 Confidential and Proprietary Information of ZTE CORPORATION
For the subscribers in the settlements or office buildings, the
different service access modes can be used according to the
premises network resource status of the carrier.
With the Category-5 cables, use the LANSwitch access
mode, and the ES2202 is configured.
With the copper cables resource, use the VDSL access
mode, and the ZXDSL9210 and 9426 are configured.
If the subscriber areas are separated, with the copper
cables resource, use the ADSL access mode, and the
ZXDSL8220 or 8426 is configured.
If the subscriber areas are separated, without the copper
cables resource, use the broadband wireless access mode,
and the WLAN, MMDS or LMDS is configured, thus
supporting the "wired + wireless" integrated networking
solution.
For the cities with the large amount ADSL access, many
DSLAMs are configured in the external end office, and the
ATM interface of the ZXA10 S300 is used to provide the
service convergence and reliable networking for the
DSLAMs. On
requirements that the carriers expect to complete the
service port convergence with the lower cost and reduce
the BAS port waste.
For the status that the carriers configure the S series
access devices of the B10 in some places of the access
layer, the ATM interface of the ZXA10 S300 can be used
to provide the convergence multiplexing and unified
networking for the S series devices.
Hybrid Networking of ZXA10 S 300
and ZXA10 & ZXE10
The ZXA10 S300 can bear the hybrid networking of the TDM
service (2 M and 34 M), IP packet (MAC frame), ATM cell, ZXA10
and ZXE10, and provide the integrated solution for subscribers,
as shown in Figure 30.
the other hand, it can meet the