Zte ZXA10 S300 Technical Manual page 31

Forcing alarm insertion (a time parameter can be
configured for automatic recovery)
Starting/stopping
information of the core board and line cards.
Querying the transceived S1 byte, K1/K2 byte and
J0/J1/J2 byte.
Enabling/disabling the optical module in the optical
line/tributary board (a time parameter can be configured
for automatic recovery).
Printing the debugging
information of the line cards or core board is printed by
the maintenance module.
Communication link test: The NMS provides a command
similar to PING command to test the packet loss rate
from the NMS to the NE core board and line cards.
Using the BER statistics function provided by the mapping
chip to test the BER of the channel without the BER tester
(the corresponding performance point should be added
into the performance management module).
EOS related maintenance functions
Forcing the software reset and hardware reset of the EOS
line card.
Communication link test: The NMS provides a command
similar to PING command to test the packet loss rate
from the NMS to the EOS line card.
Querying the CPU occupancy.
Uploading the configuration data.
Downloading the EOS version.
Starting/stopping the printing of the line card debugging
information.
Querying the port status.
Querying the VLAN Table status.
Querying the Multicast Table status.
Querying the STP working status.
Querying the LACP working status.
ATM related maintenance functions
Software reset and hardware reset of the board
Downloading the ATM version.
Uploading the configuration data.
Querying the CPU occupancy.
Reading the S1 byte of the ATM optical interface.
Confidential and Proprietary Information of ZTE CORPORATION
the printing of
information:
Chapter 1 Overview
the debugging
All debugging
19