Recommended Test Equipment - Ametek UPLC CU44-VER04 Applications Manual

Table 4–1 shows the equipment you use to verify and/or test your UPLC™ unit.
Equipment
High-Impedance Selective Level Meter, 380 Hz to 1 MHz
(Rycom 6021A)
1
Reflected Power Meter, Auto VLF Power SWR Meter
(Signal Crafter 70)
1
Frequency Counter, 80 MHz (H/P5381A)
Non-Inductive Resistor, 50 or 75Ω, 25W (Pacific)
Signal Generator (H/P 3325A, Signal Crafter Model 90)
WE RECOMMEND THAT THE USER OF THIS EQUIPMENT BECOME THOROUGHLY ACQUAINTED WITH
THE INFORMATION IN THESE INSTRUCTIONS BEFORE ENERGIZING THE UPLC™ AND ASSOCIATED
ASSEMBLIES. YOU SHOULD NOT REMOVE OR INSERT PRINTED CIRCUIT MODULES WHILE THE UPLC™
IS ENERGIZED 2 . ALL INTEGRATED CIRCUITS USED ON THE MODULES ARE SENSITIVE TO AND CAN BE
DAMAGED BY THE DISCHARGE OF STATIC ELECTRICITY. YOU SHOULD ALWAYS OBSERVE ELECTRO-
STATIC DISCHARGE PRECAUTIONS WHEN HANDLING MODULES OR INDIVIDUAL COMPONENTS. FAIL-
URE TO OBSERVE THESE PRECAUTIONS CAN RESULT IN COMPONENT DAMAGE.
Indicates "or equivalent" of the recommended equipment item.
1
Except for Power Amp and Power Supply modules.
2
Chapter 4. Test Equipment
Table 4–1. Recommended Test Equipment.
1
1
CAUTION
!
Copyright © AMETEK
Application
Impedance Matching
Transmitter Power Verification
Receiver Margin Verification
Channel Impedance Matching at Carrier
Output
Transmitter Frequency Verification
Transmitter Termination
General ac output for lab measurements
4