Dnp Binary Inputs (Uplc Inputs) - Ametek UPLC CU44-VER04 Applications Manual

8.2 DNP Binary Inputs (UPLC
Inputs)
The UPLC™ has five physical binary inputs that
can be assigned numerous functions chosen from a
selection menu. The following tables include all
possible input selections for the UPLC™ ON-OFF
and FSK modes. Since there are only five inputs
Figure 8–3 DNP Binary Inputs / UPLC Inputs Settings Page
Table 8–1 UPLC Inputs – DNP Points for ON-OFF Mode
Point Name
0 Carrier Start Key
1 Carrier Stop Key
2 Low Level Key
3 CB Alarm Reset
4 CB Test Initiate
5 Loop Test Initiate
6 User SOE 1 Key
7 User SOE 2 Key
8 User SOE 3 Key
9 High Power Key
10 Low Power Key
May 2012
and many possible selections, at any given time
some of these selections will be unassigned or not
used. The on-line bits of these unassigned selec-
tions will be set to zero.
(Admin > Protocol > DNP > UPLC Inputs)
Setting Mode
All ON-OFF Modes
All ON-OFF Modes
All ON-OFF Modes
Checkback Option Only
Checkback Option Only
Checkback Option Only
All ON-OFF Modes
All ON-OFF Modes
All ON-OFF Modes
All ON-OFF Modes
All ON-OFF Modes
Chapter 8. Protocols
Definition
Carrier Start Input has been Keyed
Carrier Stop Input has been Keyed
Low Level Keying Input has been Keyed
Checkback Alarms have been Reset
Checkback Test has been Initiated
Loop Back Test has been Initiated
SOE Event 1 Input has been Keyed
SOE Event 2 Input has been Keyed
SOE Event 3 Input has been Keyed
High Power Level has been Keyed
Low Power Level has been Keyed
8
Page 8–3