Dnp Binary Inputs / Uplc Outputs Settings Page - Ametek UPLC CU44-VER04 Applications Manual

Figure 8–4 DNP Binary Inputs / UPLC Outputs Settings Page
Table 8–3 UPLC Outputs – DNP Points for FSK Mode
Point Name
13 General Failure
14 RX Fade Alarm
15 RX Noise Alarm
16 RX Good Chanel
17 TX Refl Pwr Alarm All FSK
18 TX Main RF On
19 TX Red. RF On
20 Main PA Alarm
21 Red. PA Alarm
22 Main PS Alarm
23 Red. PS Alarm
24 Trip 1 Out
25 Trip 2 Out
26 Guard 1 Out
27 Guard 2 Out
28 CB Trip 1 Out
29 CB Trip 2 Out
30 Trip Pos. Out
31 Trip Neg. Out
32 TX Shift High Freq All FSK
33 TX Shift Low Freq
34 TX Shift Ch A Trip
35 TX Shift Ch B Trip
36 TX Shift ChAB Trip 4 Freq. Only
May 2012
(Admin > Protocol > DNP > UPLC Outputs)
Setting Mode Definition
All FSK Hardware Failure in the UPLC
All FSK Rec. Level has Dropped Below Fade Alarm Setting
All FSK Noise Alarm has Occurred
All FSK Channel Good (Rec. Signal Level & Freq. OK)
% Refl Power Exceeded Alarm Threshold Setting
All FSK TX Level on Main Power Amp Above 0.5W
All FSK TX Level on Redundant Power Amp Above 0.5W
All FSK Main Power Amp has Failed
All FSK Redundant Power Amp has Failed
All FSK Main Power Supply has Failed
All FSK Redundant Power Supply has Failed
Non-PC FSK Trip 1 Output Present (LF Trip for 2F,
Line Relay Trip for 3F, Trip A for 4F)
3F/4F Only Trip 2 Output Present (DTT Trip for 3F, Trip B for 4F)
Non-PC FSK Guard 1 Output Present (HF Guard for 2F
LR Guard for 3F, Guard A for 4F)
3F/4F Only Guard 2 Output Pres. (DTT Guard/3F, Guard B/4F)
Non-PC FSK Checkback Trip 1 Output Present (Rec. Trip 1 Freq.)
3F/4F Only Checkback Trip 2 Output Present (Rec. Trip 2 Freq.)
Phase Comp. Trip Positive Output Present
Phase Comp. Trip Negative Output Present
Transmit Freq. Commanded to Shift High in Freq.
All FSK Transmit Freq. Commanded to Shift Low in Freq.
4 Freq. Only TX Freq. Keyed to Chan A Trip Freq. (F4)
4 Freq. Only TX Freq. Keyed to Chan B Trip Freq. (F2)
TX Freq. Keyed to Chan A/B Trip Freq. (F1)
Chapter 8. Protocols
Page 8–5
8