Table of Contents
Advertisement
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run tool grinder:
1.
Clear all setup tools away from machine.
2.
Connect machine to power supply.
3.
Access ON/OFF switch by pulling down on
red release button on face of switch cover.
4.
Stand to side of machine, away from wheel.
Turn machine ON by pressing green ON
button. Allow wheel to reach full speed and
rotate for at least one minute, then turn OFF.
The motor should run smoothly and without
unusual problems or noises.
-16-
Inspections &
Adjustments
The following list of adjustments were performed
at the factory before the machine was shipped:
•
Gib Adjustments ..............................Page 31
•
Belt Adjustments .............................Page 32
Be aware that machine components can shift
during the shipping process. Pay careful atten-
tion to these adjustments during operation of the
machine. If you find that the adjustments are not
set according to the procedures in this manual or
your personal preferences, re-adjust them.
After the first 16 hours of use, the round belt
will stretch and seat into the pulley grooves.
The belt must be retensioned after this
period to ensure proper power transmis-
sion and avoid reducing belt life. Refer to
Belt Tension & Replacement on Page 31 for
detailed instructions.
Model T10814 (Mfd. Since 5/15)
Advertisement
Table of Contents
