Spark Deflector Adjustment; Test Run - Grizzly T10875 Owner's Manual

Spark Deflector
Adjustment
The spark deflector prevents sparks from shower-
ing the top of the workpiece and the operator's
hands. As the wheel wears, loosen the mounting
screws shown in Figure 12, and adjust the spark
deflector closer to the grinding wheel to maintain
a gap of ⁄ " – ⁄ ", then re-tighten mounting screws.
1 1
8 4
If the gap reaches ⁄ " and no additional adjust-
1
4
ments can be made, replace the grinding wheel.
Figure 12. Example of correct spark deflector
gap.
Model T10875 (Mfd. Since 01/15)
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning properly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
Mounting
machine until the information is understood.
Screws
⁄ " – ⁄ "
1 1
8 4
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run machine:
1.
2.
3.

Test Run

Clear all setup tools away from machine.
Connect machine to power supply.
Turn machine ON, verify motor operation,
and then turn machine OFF.
The motor should run smoothly and without
unusual problems or noises.
Note: A small amount of vibration during
operation is normal.
-15-