Installing/Removing Wheel - Grizzly T10814 Owner's Manual

Installing/Removing
Wheel
Tools Needed
Hex Wrench 5mm .............................................. 1
Phillips Head Screwdriver #2 ............................ 1
Face Spanner Wrench....................................... 1
To install/remove grinding wheel:
1. DISCONNECT MACHINE FROM POWER!
2. Remove cap screw covering spindle lock
access hole, and insert Phillips head screw-
driver into hole (see Figure 10).
Spindle Lock Access Hole
Figure 10. Screwdriver inserted in spindle lock
access hole.
3.
Rotate grinding wheel by hand until screw-
driver enters completely. This will lock the
spindle in place so it cannot rotate.
-20-
4. Use face spanner wrench to unscrew and
remove spindle lock nut and washer (see
Figure 11).
Qty
Figure 11. Spindle lock nut securing wheel to
5.
Slide grinding wheel off of spindle.
6.
Inspect replacement wheel for defects (see
Wheel Inspection on Page 19).
7.
Slide replacement grinding wheel onto spin-
dle, followed by large washer and spindle
lock nut.
8.
Retighten spindle lock nut using face spanner
wrench.
Do not overtighten the spindle lock nut
when mounting the grinding wheel. This
can damage the grinding wheel and make it
difficult to remove the lock nut later.
9.
Remove screwdriver from spindle lock access
hole, and re-install cap screw.
Note: If grinding wheel is new, refer to
Truing/Dressing Wheel on Page 21 for fur-
ther instructions.
Spindle Lock Nut
grinder
Model T10814 (Mfd. Since 5/15)