Installing/Removing Tooling - Grizzly T10814 Owner's Manual

Installing/Removing
Tooling
The Model T10814 Tool Grinder comes with five
collets ( ⁄ ", ⁄ ", ⁄ " ⁄
1 1 3 1
8 4 8 2
wide range of tool sizes.
Cutting tools are sharp and can easily cut
you. Use heavy leather gloves or shop rags
to protect your hands when handling tools.
To install tooling:
1. DISCONNECT MACHINE FROM POWER!
2. Insert tooling in collet that most closely
matches shank diameter of tooling. If collet is
too large, tooling will move during grinding.
3. Place collet in tool holder quill (see Figure
19).
Figure 19. Example of collet and tooling installed
in tool holder quill.
-24-
", ⁄ ") to accommodate a
5
8
Collet
Tool Holder
Quill
Note: Interior of quill has an alignment pin
that must be aligned with slot in collet (see
Figure 20).
Figure 20. Slot must be aligned with pin inside
of quill.
4. Shift quill selection lever to the righthand
position to lock quill rotation.
5. Thread handwheel onto end of collet and
tighten.
To remove tooling:
1. DISCONNECT MACHINE FROM POWER!
2. Shift quill selection lever to righthand position
to lock quill rotation.
3.
Unscrew handwheel from collet and set
aside.
4.
Slide collet out of quill. You may need to tap
the collet gently to remove it.
5.
Remove tooling from collet.
Model T10814 (Mfd. Since 5/15)
Alignment Slot