Oil Reset Service (Only Applies To Creader 7001/7011F/8001/8011/ 8021/9081); Electronic Parking Brake Reset (Only Applies To Creader 7011F/ 8001/8011/8021/9081); Steering Angle Sensor (Only Applies To Creader 7011F/8021/9081); Battery Maintenance System Reset (Only Applies To Creader 7011F/ 8011/8021/ 9081) - Launch CReader 6011 User Manual
Creader series
Table of Contents
Advertisement
LAUNCH
5.3.1 Oil Reset Service (Only applies to CReader 7001/7011F/8001/8011/
8021/9081)
This function allows you to perform reset for the engine oil life system, which
calculates an optimal oil life change interval depending on the vehicle driving
conditions and climate.
This function can be performed in the following cases:
1. If the service lamp is on, you must provide service for the car. After service,
you need to reset the driving mileage or driving time so that the service lamp
turns off and the system enables the new service cycle.
2. After changing engine oil or electric appliances that monitor oil life, you need to
reset the service lamp.
5.3.2 Electronic Parking Brake Reset (Only applies to CReader 7011F/8001/
8011/8021/9081)
1. If the brake pad wears the brake pad sense line, the brake pad sense line
sends a signal sense line to the on-board computer to replace the brake pad.
After replacing the brake pad, you must reset the brake pad. Otherwise, the car
alarms.
2. Reset must be performed in the following cases:
a) The brake pad and brake pad wear sensor are replaced.
b) The brake pad indicator lamp is on.
c) The brake pad sensor circuit is short, which is recovered.
d) The servo motor is replaced.
5.3.3 Steering Angle Sensor (Only applies to CReader 7011F/8021/9081)
To reset the steering angle, first find the relative zero point position for the car to
drive in straight line. Taking this position as reference, the ECU can calculate the
accurate angle for left and right steering.
After replacing the steering angle position sensor, replacing steering mechanical
parts (such as steering gearbox, steering column, end tie rod, steering knuckle),
performing four-wheel alignment, or recovering car body, you must reset the
steering angle.
5.3.4 Battery Maintenance System Reset (Only applies to CReader 7011F/
8011/8021/ 9081)
This function enables you to perform a resetting operation on the monitoring unit
of vehicle battery, in which the original low battery fault information will be cleared
CReader Series English User's Manual
19
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the CReader 6011 and is the answer not in the manual?
Questions and answers
как обновить лаунч 6011
To update the Launch CReader 6011, follow these steps:
1. Select Tool Information: Navigate to [Tool Information] and press [OK].
2. Obtain Register Code: The Register Code will be displayed. Note this code for later use.
3. Reopen CR Update Suite: Open the CR Update Suite and select the updates you want to install or click [Select All], then click [Download].
4. Power the Tool: Connect the device to a computer via USB or to a vehicle via the OBDII port.
5. Start Update: The tool will prompt for an upgrade. Click [OK] to start updating.
6. Wait for Completion: A progress bar will appear. The update may take several minutes if the file is large.
7. Finish: Once the update is complete, the registration and upgrade process is done.
This answer is automatically generated