Ipv6 Routing - D-Link DSL-2640U User Manual

DSL-2640U Wireless ADSL2+ Router with Ethernet WAN Support
User Manual
To edit an existing route, select a needed field in the relevant line of the table, change its value, and
click the Apply button.
To remove an existing route, select the checkbox located to the left of the relevant line in the table
and click the Delete button. Then click the Apply button.
If you need to specify a host from the LAN as the default route, select the <Auto> value from the
Via Interface drop-down list, enter 0.0.0.0 in the Destination network and Destination
netmask fields, enter the IP address of the host from the LAN in the Gateway field, and then
click the Apply button.

IPv6 Routing

On the Advanced / IPv6 routing page, you can add static routes (routes for networks that are not
connected directly to the device but are available through the interfaces of the device) into the
system.
To create a new route, click the Add button. In the line displayed, you can specify the following
parameters:
Parameter
Destination network
Gateway
Figure 80. The Advanced / IPv6 routing page.
A destination network to which this route is assigned. You can specify
an IPv6 address (2001:db8:1234::1) or an IPv6 address with a
prefix (2001:db8:1234::/64).
An IPv6 address through which the destination network can be
accessed. The field is available when the <Auto> value is selected
from the Via Interface drop-down list of this line.
Page 106 of 146
Configuring via Web-based Interface
Description