Ipv6 Routing - D-Link DIR-822 User Manual

DIR-822 AC1200 Wi-Fi Router
User Manual

IPv6 Routing

On the Advanced / IPv6 routing page, you can add static routes into the system.
To create a new route, click the Add button. In the line displayed, you can specify the following
parameters:
Parameter
Destination network
Gateway
Metric
After specifying the needed parameters, click the Apply button.
To edit an existing route, select a needed field in the relevant line of the table, change its value, and
click the Apply button.
To remove an existing route, select the checkbox located to the left of the relevant line in the table
and click the Delete button. Then click the Apply button.
Figure 130. The Advanced / IPv6 routing page.
A destination network to which this route is assigned. You can specify
an IPv6 address (2001:db8:1234::1) or an IPv6 address with a
prefix (2001:db8:1234::/64).
An IPv6 address through which the destination network can be
accessed.
A metric for the route. The lower the value, the higher is the route
priority. Optional.
Page 166 of 212
Configuring via Web-based Interface
Description